Redface
04-12-2015, 04:34 PM
I'm in the final stages of an upgrade to my Mark II-FV. The barrel has been threaded for a suppressor, I have a tacticool stock and a new Nikon Buckmaster 3-9x40.
1) When I sent the barrel off for the machine work, I separated the barrel from the receiver. Since then, I read a thread on here saying not to. Should I be prepared for issues when I put it all back together? Edit - Mine didn't really seem press fit...it was all being held together with the pins.
2) I don't expect to change the optics. Should I use the weaver rails, or upgrade to a DNZ products game reaper mount?
3) Are there any good bedding tutorials specific to the mark ii on the web? I've searched but I've only found generic examples. This would be my first attempt at bedding.
Thanks for taking the time to read, and respond (hopefully). I'm looking forward to punching holes in paper downrange.
1) When I sent the barrel off for the machine work, I separated the barrel from the receiver. Since then, I read a thread on here saying not to. Should I be prepared for issues when I put it all back together? Edit - Mine didn't really seem press fit...it was all being held together with the pins.
2) I don't expect to change the optics. Should I use the weaver rails, or upgrade to a DNZ products game reaper mount?
3) Are there any good bedding tutorials specific to the mark ii on the web? I've searched but I've only found generic examples. This would be my first attempt at bedding.
Thanks for taking the time to read, and respond (hopefully). I'm looking forward to punching holes in paper downrange.