111 action torque specs

[jammer300]

Hi guys I did a quick search on the main page before asking this question because I am sure it has been asked multiple times and nothing came up so here it goes. Can someone tell me what the torque specs are for the action bolts on the model 111 trophy hunter in 300wm. Thanks

[jammer300]

never mind. after a little more searching I was able to find what I was looking for

[shooterfpga]

And what did you find for specs?

[jammer300]

the front action screw torqued to 30 in/lbs and the tang screw torqued to 15 in/lbs. Does this sound about right?

[shooterfpga]

Depends on the stock and those would be initial torque tuning. Whats curious is you have a long action with only two action screws and one trigger assembly wood screw?

[Teslawhiskey]

I used this method and ended up at 35 on the front and 25 at the rear on my model 11.

http://www.accurateshooter.com/technical-articles/savage-action-screw-torque-tuning/

[jammer300]

Depends on the stock and those would be initial torque tuning. Whats curious is you have a long action with only two action screws and one trigger assembly wood screw?

you are correct. it only has two action screws and a trigger assembly wood screw. I don't know if this is the accu-stock or if it is just the plain plastic stock? Is there typically a third action screw on the long actions?

[jammer300]

I just pulled the gun apart and there is no aluminum bedding block or wedge in the stock. it is just pillar bedded so I don't believe it is an accu-stock.