hothead
03-28-2015, 01:46 PM
I 'm going to be machining a 308 , Krieger barrel for my Savage Palma rifle.
The gun shoots awesome as is, I am going to be using it for F/tr shooting.
I will be using the barrel nut as I don't think .065 is enough shoulder for the 1.250
barrel. I would like to pre machine the barrel and after the next match change it out.
I need a print of tendon with thread pitch over wires.
if necessary I will wait , but barrel is in lathe indicated in ready to cut.
the reason for re barreling is to increase weight and I want a faster twist.
any help would be appreciated.
thanks, hh:confused:
also this is not my 1st barrel job. I have done a few hundred prior to this.
This is just my 1st Savage.
hh
The gun shoots awesome as is, I am going to be using it for F/tr shooting.
I will be using the barrel nut as I don't think .065 is enough shoulder for the 1.250
barrel. I would like to pre machine the barrel and after the next match change it out.
I need a print of tendon with thread pitch over wires.
if necessary I will wait , but barrel is in lathe indicated in ready to cut.
the reason for re barreling is to increase weight and I want a faster twist.
any help would be appreciated.
thanks, hh:confused:
also this is not my 1st barrel job. I have done a few hundred prior to this.
This is just my 1st Savage.
hh