300 Blackout ejection

[BarrelBurner]

Anybody done a .300 blackout and figured out how to make it eject those short little cases on a model 10 action?
Lengthened the ejector protrusion but still not keeping it on the extractor claw quite long enough to clear the port.
:confused:

[Zen Archery]

Are you using standard AAC shells or recut 556? How new is the 300?

[BarrelBurner]

Have tried both new and cut down. pushed case length as far as chamber would handle with no success there either.
Action is brand new.

[Hotolds442]

Are you using the 223 extractor by chance? If you have a standard extractor, it will release early even with standard 223 cartridges. The Savage part number for the 223 extractor is 102278.

[BarrelBurner]

It is the .223 extractor, actually was a brand new center feed .223.
Ended up making a longer ejector plunger and has resolved the ejection problem, but in turn the last round out of the magazine can be a little stubborn to feed now. (Hangs under the plunger sometimes).

[Twostepct]

I built one on an Axis so I'm not sure how much it will help you but I did three things that made it reliable. I first increased the travel of the ejector. I then replaced the detent ball under extractor which made a difference. The best thing I did though was ordering a modified extractor and ejector from sharp shooter supply. It I'd hard to place an order with them but the parts made my rifle 100% reliable so far so it was worth it.