Mark II F E Receiver - I Need To Get my Scope Mounted Further Back

[gapi]

Hi Good Folks of Savage Shooters, New Member, First Post.

I have a new Mark II F .22 and I usually mount my scopes further back than most. I am finding mounting options for the Mark II are narrow, unless I am missing something.

A half inch would be great.

Thanks

http://alcphoto.net/savage/mark2_f_webb01.jpg

[short round]

Check out Diversified Innovative Products.

[gapi]

Thanks But,

I need the front mount to come back. The scope is as far as it can be rearward in the front ring.

I see the 93 Series Left Hand Scope Mount (https://www.diproductsinc.com/Detail.aspx?PROD=126143&CAT=3602) if reversed would allow this, but in the process partially cover or obstruct the ejection port.
Would that be an issue other than looking like a mud-hut misfit?

If not, are there full rails with a matching contour available? Can a full rail without a cutout work?

I am a machinist and can drill and countersink my own holes but would rather not unless they were steel I could re-blue.
And although we can do this and that in the shop on my job, I would just rather purchase something. I am not sure how "Gun Parts" would go over.

One way or another I'm going to get her back, and try to make it look natural if I can.

Also, does everyone have to do the Captcha Verification everytime they post, always? Really?

http://alcphoto.net/savage/mark2_f_webb02.jpg

Thanks

[Hotolds442]

Site sponsor EGW has the solution you're looking for. The one piece rail won't interfere with ejection at all.
Captcha? Never had to use it.

[gapi]

I ordered one thanks