View Full Version : Mark I/II/93R: Mark II F E Receiver - I Need To Get my Scope Mounted Further Back
Hi Good Folks of Savage Shooters, New Member, First Post.
I have a new Mark II F .22 and I usually mount my scopes further back than most. I am finding mounting options for the Mark II are narrow, unless I am missing something.
A half inch would be great.
Thanks
http://alcphoto.net/savage/mark2_f_webb01.jpg
short round
02-15-2015, 04:22 AM
Check out Diversified Innovative Products.
Thanks But,
I need the front mount to come back. The scope is as far as it can be rearward in the front ring.
I see the 93 Series Left Hand Scope Mount (https://www.diproductsinc.com/Detail.aspx?PROD=126143&CAT=3602) if reversed would allow this, but in the process partially cover or obstruct the ejection port.
Would that be an issue other than looking like a mud-hut misfit?
If not, are there full rails with a matching contour available? Can a full rail without a cutout work?
I am a machinist and can drill and countersink my own holes but would rather not unless they were steel I could re-blue.
And although we can do this and that in the shop on my job, I would just rather purchase something. I am not sure how "Gun Parts" would go over.
One way or another I'm going to get her back, and try to make it look natural if I can.
Also, does everyone have to do the Captcha Verification everytime they post, always? Really?
http://alcphoto.net/savage/mark2_f_webb02.jpg
Thanks
Hotolds442
02-15-2015, 11:03 AM
Site sponsor EGW has the solution you're looking for. The one piece rail won't interfere with ejection at all.
Captcha? Never had to use it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.