View Full Version : Bas
reynoldsfamily3
01-11-2015, 10:22 PM
I am trying to find out if there is a recommended or commonly used amount of torque for tightening the BAS. I have searched, but the only answer I have found is "tight" and "very tight". Does anyone use a certain setting?
Thanks
Bill
olddav
01-11-2015, 11:42 PM
No torque setting required for BAS, just crank on it a bit.
bootsmcguire
01-11-2015, 11:43 PM
Just nice and tight by hand.
No need to additional torque, the flange of the BAS should stop once it pinches the bolt handle to the bolt body.
reynoldsfamily3
01-12-2015, 08:59 AM
Thanks Guys
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.