tackdriving
10-28-2014, 08:18 AM
Hi All,
I removed the receiver/barrel on a SA 111 LRH for some modification work and need some guidance on reinstalling. I read the thread titled Proper Torque Sequence for the AccuStock but that does not seem to apply to my setup as I only have two bolts for attaching the receiver/barrel (one long one in the back just forward of the trigger guard and one in front of the magazine). I'm also not sure what the "recoil lug" is or if it even applies to my setup. I assume I should follow the methodology, however, by performing the following sequence of steps.
Install the front screw first to 10 in-lbs, then back out one-half turn
Install the rear screw to 10 in-lbs
Repeat 1 and 2 with increasing torque (increments of 5-10?) until it is tightened to 45 in-lbs
Is that the correct sequence? Do you recommend using Blue Locktight or is that overkill?
Thanks, Dave
I removed the receiver/barrel on a SA 111 LRH for some modification work and need some guidance on reinstalling. I read the thread titled Proper Torque Sequence for the AccuStock but that does not seem to apply to my setup as I only have two bolts for attaching the receiver/barrel (one long one in the back just forward of the trigger guard and one in front of the magazine). I'm also not sure what the "recoil lug" is or if it even applies to my setup. I assume I should follow the methodology, however, by performing the following sequence of steps.
Install the front screw first to 10 in-lbs, then back out one-half turn
Install the rear screw to 10 in-lbs
Repeat 1 and 2 with increasing torque (increments of 5-10?) until it is tightened to 45 in-lbs
Is that the correct sequence? Do you recommend using Blue Locktight or is that overkill?
Thanks, Dave