Savage 64 Speed loader?

[jumperj]

I've been looking around on here, but haven't found anything on it. I bought a "Baby UpLula" To help me load my mags on a model 64. It doesn't fit the mags. Is there a speed loader out there that fits the Savage 64 magazine? They have sharp corners on the bottoms and after 5 or 6 mags, my hands are getting pretty sore. Any suggestions?:yield::help:

[bremereric]

The baby uplula is for pistol loads. .380 and lower.

[Palms]

Reloaded magazines more than 50 times on a weekend full and partially for an Appleseed = no fingers left! It makes you appreciate the older mags as they are easier to load. If someone finds an easy loader for those 64 mags please please post.

[fartsinpublic]

I'm just hoping for a belt-fed conversion for it. Why bother with mags? :)

[jumperj]

I think I'm going to attack the corners of those mags with my dremmel and see if it helps. I enjoy shooting that rifle.. Hate loading those mags.

[RRRoger]

I've been looking around on here, but haven't found anything on it. I bought a "Baby UpLula" To help me load my mags on a model 64. It doesn't fit the mags. Is there a speed loader out there that fits the Savage 64 magazine? They have sharp corners on the bottoms and after 5 or 6 mags, my hands are getting pretty sore. Any suggestions?:yield::help:

I used fine wet/dry sandpaper and dulled the edge where the bullets enter/exit the magazine.

[RRRoger]

RAEIND Magazine Loader Unloader for German Sports Gun 1911-Firefly GSG .22LR Handgun Speed Loader Mag Loader (https://www.amazon.com/RAE-Industries-RAEIND-Firefly-Magazine/dp/B07GJP2PHD/ref=sr_1_2?keywords=Savage+Arms+Savage+64+Series+. 22+LR+Magazine+Speed+Loader&qid=1563630113&s=gateway&sr=8-2)


(https://www.amazon.com/RAE-Industries-RAEIND-Firefly-Magazine/dp/B07GJP2PHD/ref=sr_1_2?keywords=Savage+Arms+Savage+64+Series+. 22+LR+Magazine+Speed+Loader&qid=1563630113&s=gateway&sr=8-2)




$12.98 (https://www.amazon.com/RAE-Industries-RAEIND-Firefly-Magazine/dp/B07GJP2PHD/ref=sr_1_2?keywords=Savage+Arms+Savage+64+Series+. 22+LR+Magazine+Speed+Loader&qid=1563630113&s=gateway&sr=8-2)


FREE Shipping

I just lightly rubber fine wet/dry sandpaper on the sharp edge and it works for me.

[Fasteddie01]

Hi RRRoger - Thanks for bringing this thread back to life ;-) I posted a comment (many mods, search my posts) about mags and other repairs and mentioned the 'Quickie loader' from Hiljak https://hilljak.com/shop?olsPage=t%2F22lr&page=2 . They make loaders for lots of different magazines. The one for 64s runs $10.99 + shipping and they're an Ohio small Mfg. I live in Canada and with shipping it would have cost me over $30, so I made my own, using a plastic 35mm film canister, a screw, and a bit of a click-pen tube. Works for me for a 1/2 hour build instead of $30 :p
https://i.postimg.cc/dZCnz9fS/Sav-64-mag-loading-tool.jpg