clintsrv
08-06-2014, 10:46 PM
Last week I asked if any one had installed SF action into CF stock with bottom metal. I decided I was going to find out.
DBM set up would not work without substantial modification to action. So I then thought the hinged floor plate design could possibly work.
So I ordered the parts from Savage. The complete HFP assembly was a little on the high side at $148 after shipping. But it was the only way to go.
Modifications to both bottom metal and SF box mag were needed. Both of which merely required either minor cutting or grinding.
The box mag on SF action could still be used as normal in SF stock if wanted. However, the CF HFP assembly has been modified past the point of using it for its original purpose.
http://img.tapatalk.com/d/14/08/07/9a9ejuru.jpg
http://img.tapatalk.com/d/14/08/07/5emymupe.jpg
http://img.tapatalk.com/d/14/08/07/equdebe4.jpg
http://img.tapatalk.com/d/14/08/07/uzu3ugyd.jpg
http://img.tapatalk.com/d/14/08/07/ahavypep.jpg
http://img.tapatalk.com/d/14/08/07/ubyqujav.jpg
http://img.tapatalk.com/d/14/08/07/y2eda8uh.jpg
http://img.tapatalk.com/d/14/08/07/e9a9y3ut.jpg
http://img.tapatalk.com/d/14/08/07/jagepeza.jpg
http://img.tapatalk.com/d/14/08/07/enatery9.jpg
The box mag fits right into the cutout in stock. The follower slides into place in bottom plate. It feeds basically the same as a SF would with a blind mag.
DBM set up would not work without substantial modification to action. So I then thought the hinged floor plate design could possibly work.
So I ordered the parts from Savage. The complete HFP assembly was a little on the high side at $148 after shipping. But it was the only way to go.
Modifications to both bottom metal and SF box mag were needed. Both of which merely required either minor cutting or grinding.
The box mag on SF action could still be used as normal in SF stock if wanted. However, the CF HFP assembly has been modified past the point of using it for its original purpose.
http://img.tapatalk.com/d/14/08/07/9a9ejuru.jpg
http://img.tapatalk.com/d/14/08/07/5emymupe.jpg
http://img.tapatalk.com/d/14/08/07/equdebe4.jpg
http://img.tapatalk.com/d/14/08/07/uzu3ugyd.jpg
http://img.tapatalk.com/d/14/08/07/ahavypep.jpg
http://img.tapatalk.com/d/14/08/07/ubyqujav.jpg
http://img.tapatalk.com/d/14/08/07/y2eda8uh.jpg
http://img.tapatalk.com/d/14/08/07/e9a9y3ut.jpg
http://img.tapatalk.com/d/14/08/07/jagepeza.jpg
http://img.tapatalk.com/d/14/08/07/enatery9.jpg
The box mag fits right into the cutout in stock. The follower slides into place in bottom plate. It feeds basically the same as a SF would with a blind mag.