cutting a DBM in new Stock

[Rotorhead19]

Looking for some info into cutting into a new Choate tactical stock. I have a Savage 110 with a DBM, but the stock I purchased from Choate is for a center feed, so I need to cut a hole in the bottom of the synthetic stock for the magazine. I am looking for some insight into how to cut the extra material out as I have never done this before. Should I use a drill press to drill out the four corners and dremel out the rest? Any thoughts?

[KRP]

You could do it with a drill press and a dremel. I think you'll wish you had a mill or had taken it to someone that does very shortly though.

[buxman66]

If you used the search function on this board you'll find this has been asked numerous times.there are contact #'s in these posts of companies that provide this service using CNC milling equipment.