CAN SOMEONE HELP ME

[223DRIVER]

Ok Im dumb but opened my bolt and pushed over the lug that cocks it. how do I undo it I cant get my bolt out.

[deadeye]

You said you opened your bolt - do you mean you took it apart or out of the gun?

You also said you cant get the bolt out but you said you opened it? Did you remove the rear screw while it was in the gun?? I am confused what you did.

[223DRIVER]

its not out ofthe gun just opened

[223DRIVER]

bolt handle is still on it just opened like if you were to load it. I just pushed the lug on the bolt thatcocks it and now its stuck that way.

[223DRIVER]

got it just pinched the heck out of my finger. lesson learned.

[223DRIVER]

ok i know i should know this but how do you get the bolt out so i can clean it

[223DRIVER]

forget it i finaly got it thanks for the help. ;D

[deadeye]

Pulling the trigger while pushing down the lever on the right hand side of the action will move the bolt stop out of the way for removal. This will allow you to take it out. Then you can either push very hard to recock it before installing or you can loosen the rear screw relieving spring pressure and then push it back into cocked position. If you have never removed the rear screw it can be a pain the first time. Put it on the floor with an Allen wrench installed and step on the bolt to hold it and use the other foot to step on the Allen wrench to pop it loose.

[pdog06]

what made you uncock it while still in the gun??? My first thought was " thats gonna be a pain to recock while in the gun". Guess it was more of a pain than I thought.

Glad to see you got it figured out. To put the bolt back in you do the reverse of taking it out, minus the finger pinching...LOL