35Whelenshooter
02-27-2014, 01:50 AM
Hello,
I'm sure that there has been many posts on this, but I'm unable to seem to find them. I would like to be able to stiffen the front part of the forearm. I would like to inlay the forearm so that I could use carbon arrows cut to length and glue in or use accugel or devcon.
To open the channel up, I will use a doll rod wrapped with sandpaper. This will allow me to use the bigger barrels in the factory plastic stocks. The best that I can tell, my stocks that I have, look to have steel pillars in them. Their was a post somewhere that had very good photos of in letting the forearm and the receiver.
I have two long and short actions that I will need to glass bed and stiffen the forearms of the stocks. One of the long actions is in 7MM Rem Ulta mag.
Any and all help on this topic I say thank you.
I'm sure that there has been many posts on this, but I'm unable to seem to find them. I would like to be able to stiffen the front part of the forearm. I would like to inlay the forearm so that I could use carbon arrows cut to length and glue in or use accugel or devcon.
To open the channel up, I will use a doll rod wrapped with sandpaper. This will allow me to use the bigger barrels in the factory plastic stocks. The best that I can tell, my stocks that I have, look to have steel pillars in them. Their was a post somewhere that had very good photos of in letting the forearm and the receiver.
I have two long and short actions that I will need to glass bed and stiffen the forearms of the stocks. One of the long actions is in 7MM Rem Ulta mag.
Any and all help on this topic I say thank you.