View Full Version : Standard Go Gauge Protrusion?
Is there a standard spec to use for go gauge protrusion on a prefit? A prefit i had in 6.5x47 measured .130". Just wondering if there was a standard that savage uses or the guys that make prefits use?
bootsmcguire
01-18-2014, 12:39 PM
.125" to .130" is what I am told for Savage prefits.
Kind of what I thought. I would guess that .130 would be considered max seeing as how most bolt faces fall in the .115-.117 for depth. Does this hold true for all sizes? 223/308/magnum?
bootsmcguire
01-18-2014, 01:05 PM
As I was instructed by someone who definitely knows, it is that spec for everything.
sharpshooter
01-19-2014, 11:39 PM
Everything BUT the 110BA in .338 Lapua. It should be .145-.150".
bootsmcguire
01-19-2014, 11:50 PM
Everything BUT the 110BA in .338 Lapua. It should be .145-.150".
Thanks Fred. I didn't know about that one, but then again I am not a 338L fan anyway.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.