broncbob
01-16-2014, 11:00 PM
I just got done putting a Savage 10 action based build into a McRee fixed stock and the tang doesn't float. It is torqued per the instructions that came with the stock to 60 inch pounds.
Should I relieve the stock to make the tang float or just run it as is? This my first time using a chassis type stock, so I'm unsure if the tang floating rule would apply? The only place it contacts is the center of the tang under the safety.
Should I relieve the stock to make the tang float or just run it as is? This my first time using a chassis type stock, so I'm unsure if the tang floating rule would apply? The only place it contacts is the center of the tang under the safety.