moecarama
12-28-2013, 09:37 PM
Ok, this project is coming together,BTW short action small shank, I used magnum firing pin from CRf and really concerned about protrusion?
Should I shorten to length by turning the adjustment nut of firing pin or get another firing pin? "
I have replaced the CRF bolthead with a magnum push feed bolthead, installed new ejector,spring,retaining pin, extractor,spring and detent ball. I put it all together then checked firing pin protrusion; I am getting .076 protrusion. I beleive is a little too much since my 30.06 is set at .044 protrusion.
Should I shorten to length by turning the adjustment nut of firing pin or get another firing pin? "
I have replaced the CRF bolthead with a magnum push feed bolthead, installed new ejector,spring,retaining pin, extractor,spring and detent ball. I put it all together then checked firing pin protrusion; I am getting .076 protrusion. I beleive is a little too much since my 30.06 is set at .044 protrusion.