t4halo
12-16-2013, 02:13 AM
I have been checking this forum out for a while. I own a few 220's (410 28 20 and 12) but today I picked up a very clean 219B in 22H. I knew it needed a firing pin and didn't think it would be to hard to fix. I ordered two pins from Numrich's and pulled the stock. Upon disassembly I found the rear section of the pin but the striker was gone. Are there any helpful hints in replacing the pin. I have looked at the diagram and would like to know what steps you have used in the past.
Any advise would be great, thanks,
Tony
Any advise would be great, thanks,
Tony