View Full Version : Front screws to long....
goblin141
02-28-2010, 10:08 PM
I have a single piece mount, weaver tactical, and the front screws are a tad long. i dont have a grinder, so has anyone used washers to shorten them.
psharon97
02-28-2010, 10:47 PM
Have you tried just cutting shorter? don't have much experience in cutting mounting screws
goblin141
02-28-2010, 10:53 PM
My son walked in a few minutes a go and he has a dremel he says will work. So tuesday we put it together.
dcloco
02-28-2010, 11:04 PM
Do you have the front and rear screws switched?
rjtfroggy
03-01-2010, 08:09 AM
[quote=dcloco ]
Do you have the front and rear screws switched?
My thoughts exactly. Try a file if not, go a little at a time, you can never put back what you cut off.
DGD6MM
03-01-2010, 09:26 AM
I use my sharpening stone.
goblin141
03-02-2010, 10:22 PM
It turned out that all four were too long. The dremel worked fine. The package was for a model 10 savage but who knows. The mount is on and saturday we will take it shooting. The sharping stone in pinch would be a possibility.
sliderspal
03-08-2010, 10:45 AM
goblin
Which mount do you have?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.