View Full Version : Stock Torque setting for Model 12 3 screw target action???
k80skeet
10-18-2013, 01:42 PM
Does anyboby have the correct torque setting for a model 12 target stock with 3 screw target action????????????
darkker
10-19-2013, 12:17 AM
There isn't one.
jhelmuth
10-19-2013, 05:18 AM
LRPVs in the HS Precision stock is 55-60 inch pounds. That comes direct from the factory.
Laminate stocks with pillars are typically 40-45 inch pounds if they are bedded, 25-30 if they are not. That is a generalization (ymmv).
In the 3 screw configuration, I find that having the rear screw 5-10 inch pounds less works well....
Good shooting....
Jim
FW Conch
10-21-2013, 10:20 AM
I have always wondered about the 3rd screw? It seems like it could provide the potential for uneven stress or binding if not handled correctly?
Alleycat72
10-22-2013, 07:18 AM
I run 30/30/15
frank1947
10-25-2013, 11:25 AM
Trial and error maybe but i do 50 on all of them, I have tried differnt settings but I never see any difference, I kind of look at it this way, if glueing a action in to a stock is the best thing you can do then tight is good. IMHO
wareagle69
10-25-2013, 10:27 PM
http://www.accurateshooter.com/technical-articles/savage-action-screw-torque-tuning/
The above might be of interest
Stockrex
10-27-2013, 09:58 PM
When I asked this - gods responded with finger tight.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.