View Full Version : Inletting blind mag stock for savage DBM
wintermute76
02-11-2010, 01:02 PM
One of my coworkers recenty bought a 10 FP .308 centerfeed blind magazine model, non accustock.
I'm looking at replacing my 10FCP McMillans mag setup with a CDI AICS unit.
Wondering if we can inlet his stock for my factory DBM. Possible?
aubie515
02-11-2010, 07:37 PM
Anything is possible...it just takes money. Send it to Jeff at CDI...he can inlet the stock.
82boy
02-11-2010, 10:15 PM
Yes it can be done and Sharp Shooter Supply does them many times a day. This is not a project you can do with a dremel, at home.
Carvera
02-11-2010, 10:29 PM
Would it not be cheaper to buy a factory take-off stock that is inletted for the DBM/HFP, than to have the work done on a factory stock?
wintermute76
02-11-2010, 11:07 PM
I can use the mill at work to do it, one perk of being a machinist.
From the first glance at his stock on the outside, it looked like it's the same tool to mold them, just using a coring insert on the DBM models to mold the pocket.
You're right, buying a takeoff stock would be the easiest route, and that's what I told him, but it's not my rifle.
I was just wondering if it was feasible or not.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.