Galveston22
02-06-2010, 07:03 PM
http://img195.imageshack.us/img195/1931/targethm.jpg
My gun:
10FP .308 w/brake aftermarket stock bipod bushnell scope factory barrel trigger
Previously zero'd with 110gr Sierra, POI moved 1" left with the Bergers.
The load:
1x fired Lapua brass neck sized
47.0 gr Varget
Fed 210m primer
125 gr Berger match flat base
2.870" base to tip (approx .005" off lands)
est. 3000 fps
The feat:
5 consecutive shots at 100 yards off a bipod and sandbags and getting sub half inch group with a factory rifle. Actual group is .461" max spread center to center.
If that seems easy for you, then consider that I have had Parkinson's disease for 7 years and am pretty shaky.
Anyways, just wanted to share. I had an issue at the range. I extracted a chambered round when the range officer called cease fire, and ended up pulling the bullet and dumping powder in my chamber. Had to get range officer to tap the bullet out with a rod. The bullets were only seated about 3/16" into the neck. Anyways, I dont plan on doing that one again. Now, I will be picking oily Varget from the threaded part of the receiver for the next couple days.
My gun:
10FP .308 w/brake aftermarket stock bipod bushnell scope factory barrel trigger
Previously zero'd with 110gr Sierra, POI moved 1" left with the Bergers.
The load:
1x fired Lapua brass neck sized
47.0 gr Varget
Fed 210m primer
125 gr Berger match flat base
2.870" base to tip (approx .005" off lands)
est. 3000 fps
The feat:
5 consecutive shots at 100 yards off a bipod and sandbags and getting sub half inch group with a factory rifle. Actual group is .461" max spread center to center.
If that seems easy for you, then consider that I have had Parkinson's disease for 7 years and am pretty shaky.
Anyways, just wanted to share. I had an issue at the range. I extracted a chambered round when the range officer called cease fire, and ended up pulling the bullet and dumping powder in my chamber. Had to get range officer to tap the bullet out with a rod. The bullets were only seated about 3/16" into the neck. Anyways, I dont plan on doing that one again. Now, I will be picking oily Varget from the threaded part of the receiver for the next couple days.