View Full Version : Stevens 200 stock bedding
possum1
02-05-2010, 05:42 PM
I was wondering if anyone has a picture of a stevens stock that they have bedded ? It would be greatly appreciated if they could post the pic. Thank's Possum.
davemuzz
02-05-2010, 08:15 PM
http://i12.photobucket.com/albums/a212/davemuzz/DSC00583.jpg
http://i12.photobucket.com/albums/a212/davemuzz/DSC00582.jpg
I cleaned up the "glop" with a dremel after the pic's were taken. Just make sure you don't have any bedding under the recoil lug. Put a few pieces of tape under the recoil lug.
I hope this helps.
Dave
possum1
02-05-2010, 11:27 PM
Thank's for the pic's. Did you remove any material where you bedded or just left it alone ??
Blue Avenger
02-06-2010, 01:09 AM
You need to put in grooves on the sides so the epoxy will have something other then slick plastic to grip.
possum1
02-06-2010, 03:42 AM
I understand the roughing up or grooves, just wondering if you have to remove any material like you wood on a wood stock.
davemuzz
02-08-2010, 12:00 AM
I took a small Dremel grind wheel to the sides where the Davcon (peanut butter consistency kind) and roughed up the sides. I also took a small drill bit and made some shallow holes for the Davcon to flow into for additional hold.
I removed some of the plastic so the Davcon would "stick" to the stock, and yet allow the barrel to seat on the solid Davcon. So....to answer your question, YES, I did remove some of the stock material so I could have at least 3/8" of Davcon material from the barrel to the factory stock.
Dave
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.