Base for 110 flat rear

[jdpenterprises]

I have recently acquired a savage 110 preaccutrigger with the flat rear in 30-06. I have searched high and low for a 20 moa pict. base (as I will most likely convert it to a 300 win mag) without much luck. My preference is steel, but will take an aluminum base if I have to. I would prefer one with a recoil shoulder given the upcoming conversion. Warne has a 20 moa steel base, but I can't seem to find one in stock. Not sure if it has the recoil shoulder or not, but it appears to be pretty much what I am looking for. Are there any other bases for flat rear magnums close to what I am looking for?

[stangfish]

http://www.kenfarrell.com/SAV-L-1-20.html

[jdpenterprises]

Thanks! I had looked at them but didn't remember them having one for the flat rear.I have looked until I was blue in the face. I can't tell from the pic, does it have a recoil shoulder or lug? Should have known ken's base would work since the savage gurus endorse them so often.

[stangfish]

http://www.tacticalworks.com/Savage-EGW-Long-Action-Flat-Back-Tactical-Scope-Mount-20-MOA-PN41402.html

[stangfish]

No the round back one does though. Go figure. They actualy use a set screw.

[jdpenterprises]

I noticed that too after looking. I have egw bases on a 308 and 223 savage. I'm thinking I need something more beefy for a 300 win mag build. The screws will be the weak link either way I guess, that's why I was hoping for a recoil lug.

[stangfish]

A couple of things that I have seen done is bedding the mount and pinning it, you can also redrill and tap for larger screws. I know a lot of guys that shoot a 300WM that have not found a need for such drastic measures. Your situation may differ. I would say if you purchase the EGW also get the Torx screw set(buy extras) and you can get more torque on them without stripping them.

[jdpenterprises]

Wait, isn't this the correct base withe the lug? http://www.kenfarrell.com/FGF-SAV-L-1-20.html

[jdpenterprises]

Thanks. I did buy the torn screws for my two. Is this not the correct base with the lug http://www.kenfarrell.com/FGF-SAV-L-1-20.html

[jdpenterprises]

I did get the torx screws on the other two. May go the ken Ferrel route on this build. Thanks for your help.

[shoalwater]

I use nothing but ken Farrell mounts and rings on all my rifles. If anyone makes better, I haven't found it.

[stangfish]

Thanks. I did buy the torn screws for my two. Is this not the correct base with the lug http://www.kenfarrell.com/FGF-SAV-L-1-20.html

Looks right to me.

[jdpenterprises]

I ordered the base this weekend without the set screw. I do like their rings, and will definitely consider them. Spoke to Jim Briggs today about the availability of a 300wm barrel. 14 weeks for a criterion, 16 min. For a shilen. Looks like I'll have plenty of time to piece this together.