Need help finding stock for 110E-D

[Slowpoke Slim]

Hey everyone, haven't been on in quite a while. I need some help though. I need to locate a stock for an old model 110E-D in 243. This is the old flat rear receiver, 4.5" action screw spacing. The factory stock has a blind box mag with a non-release metal floor plate. The factory stock is split and I need a new one. I need it to be cheap, and drop in. I don't care if it's wood or synthetic.

Ramline used to make one, but they are discontinued now. This is just a low dollar shooter, so can't go with a custom stock.

Anyone know of a maker still listing a stock for this one?

Thanks.

Slim

[Nandy]

I don't have much to offer but it might help to know what price range are you looking for. Boyd's might have something that fit yours and their price is not bad being on around 100. If cheaper than that you might have to post a WTB thread on the classifieds here.

[Edwards]

depends on what ur price line is.
I just put a Boyd's Tacticool on my .308 with 4.5" action. Little bit of material removal..nothing terrible. I'm in the process of trying to build a sniper syle for my son...it's just a test to see if i can get the inletting correct..hell....even close.

SSS has drop in's for the 4.5"..but $$$ for my pocket
There is another company that i was recommended, but it has $400 and up.

Richards MicroFit...although not listed, I called and was told they could do any of there stocks to fit the 4.5".

Boyd's...offers a "classic" for the 4.5"
I went with the long action, removed some wood for the lug and am sending it off for the entire actions to be bedded. For $120'ish...it was the best move for me.