View Full Version : Torque action screws
jsthntn247
06-19-2013, 03:54 PM
How do yall torque your screws on your 2 screw savage actions? Do I need to torque the first one all the way down first and then the rear or the first a little, rear a little.... until they both reach the in/lbs im looking for?
rjtfroggy
06-19-2013, 04:30 PM
In all honesty if your stock does not have pillars torqueing can be a futile and/or fatal(to stock) mistake. In a wood stock torqueing too much can crush the wood and everytime you do it the screw becomes a "little" too long, in a plastic stock over torqueing runs the risk of cracking the stock.
Do it the old fashion way use a allen wrench short side up and turn in until it is tight. Do the front a little with the butt on a solid suface, then the rear and then back to front.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.