PDA

View Full Version : Looking for Striker 510 bolt options



farmhand2710
04-25-2013, 09:24 PM
I have a 510 7-08 and am looking to rebarrel to .223. I am looking for a .223 bolt, but am finding nothing. Can any of the 310 or 10 series .223 bolts be used and just replace the handle and body?
Thanks, a new guy with Striker fever:p

bootsmcguire
04-26-2013, 07:52 PM
IIRC, you will just need to change the bolt head, Strikers are left bolt handle, but right hand eject, which means they use the regular right handed bolt head. So all you should need is a standard 223 short action right handed bolt head. You do not need an entire bolt, jsut the bolt head.

snowgetter1
04-27-2013, 01:32 AM
Short action 223 bolt face and you are good. Takes about 10 min to swap out if that. I do it all the time on my striker.

farmhand2710
04-29-2013, 11:18 AM
Thanks for the replies! I was trying to decide between getting a whole seperate bolt, or just the head. I am leaning towards a second bolt to ease / quicken the change over, as it is just the barrel then with a complete bolt.

Nor Cal Mikie
04-29-2013, 06:10 PM
I would think you'll have to reset the headspace, which ever way you decide. Only takes a few thousands to change things from good to bad. Or, you just might get lucky and everything will work as planned.

bootsmcguire
04-29-2013, 11:39 PM
I would think you'll have to reset the headspace, which ever way you decide. Only takes a few thousands to change things from good to bad. Or, you just might get lucky and everything will work as planned.

Considering he is wanting to switch from 7-08 to 223 back and forth, I would hope he would reset the headspace. LOL.

bootsmcguire
04-29-2013, 11:41 PM
Also since nobody else has said it, if your striker has a mag, you'll need to change that and the follower as well to be a repeater.

Appleseed
05-01-2013, 04:45 PM
Changed my bolt head, but had to have it milled 2 places on the face and requires the firing pin hole to be drilled for the larger dia pin. Other than that, pretty easy change.