Float the tang?
Should I free float the safety tang on my new B&C Medalist stock? Everything else fit great.
pdog06
01-24-2010, 10:39 AM
I would if it is hitting. If the tang hits the stock before the rear screw area of the action it could bind the action as you tighten it up.
A little sandpaper of lightly with a dremel should take care of it, then just dab a couple coats od tru-oil or some other clear on it to seal it and make the color match the rest of the stock again(when you sand it the color will lighten up).
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.