My new bolthandle

[stangfish]

That is probably the a really good way to make it look stock. How does the factory cast metal weld? Is it WCB or something like that? I am using 316 and 304 for the shafts. Do you tig or rod with???... 309?

[sinman]

http://i290.photobucket.com/albums/ll272/sinarms/DSCF1231.jpg

I use Tig and I haven't had any problems with welding the SS or cast ones. I just use the matching handle to factory metal. I mill off the old one and drill the hole and tig it on then take it to the lathe and turn it down. I use Boot's handles

[stangfish]

Removed

[scope eye]

I am sorry to say stangfish, I will not be hanging this bolt handle on any of my rigs, instead I have decided to carry it around with me and admire it, and show it to anyone that will stop and take a look, including the postman the guys at the coffee shop strangers you name it,
then when that gets old, I am going to get a big gold chain and hang it around my neck, just like "flavor flav" again thanks for the jewelry.

Dean

[stangfish]

removed

[scope eye]

Hey I got to be sporting my bling bling, when I go to the range.

Dean

[scope eye]

On the same note, to this day I am still sending those bolt lift kits out, I keep getting those, am I too late or are they still available pm's
4 month's and 400 plus kits later, needless to sayI did not have any Idea, what I was getting in to when I started offering them, so far only one complaint, that's a pretty good run.

Tanks Dean

[stangfish]

Removed