View Full Version : Boyd's stock on model 12 flat topcoat
Orange_Crush
02-05-2013, 05:32 PM
I asked Boyd's if they made their thumb hole stock for the older model 12 flat top (pre - accutrigger ) and they said no.
Has anyone here installed a Boyd's stock on an older model 12? If so, what mods did you have to make?
rjtfroggy
02-05-2013, 05:51 PM
I have Boyd's on a couple of staggard feed flat receivers.Call back and ask if they still have the ones for 4.25 screw spacing- staggard feed.
Orange_Crush
02-05-2013, 06:06 PM
Thanks - doing that right now!
Orange_Crush
02-06-2013, 05:02 PM
My model 12 flat back is chambered in .22-250. I always thought it was a short action but the center to center distance on the stock mounting holes seems to be 5"
rjtfroggy
02-06-2013, 05:38 PM
If that is the case, and it could be if it is older, then you need a long action stagger feed stock.
jonbearman
02-07-2013, 08:45 AM
Try stockys if you cant get what you want from them.
Orange_Crush
02-07-2013, 02:11 PM
Thanks Jon Bearman - Stocky's is a little expensive considering I only paid $50 for the rifle :)
stangfish
02-07-2013, 06:52 PM
Will this one work?
http://www.boydsgunstocks.com/product.htm?pid=9449&cat=1220
http://www.boydsgunstocks.com/content/Boyds/images/500/Products/FT/06-111.jpg
Orange_Crush
02-07-2013, 06:57 PM
hey - thanks Stangfish - I think it would! I might have to hog out the barrel channel a bit but I would be up for that! Thank you!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.