View Full Version : Mark I/II/93R: Weaver T36 on Savage mark II BV?
Anyone here use a T36 on their Savage? I am looking for suggestions on Ring height and whether new mounts will be needed.
Thanks
scope eye
01-29-2013, 12:19 PM
I have Millitt med with that same set up, the high rings are 1/8" higher,
Tanks Dean
So you are using the factory bases and Millett medium rings and a T36 on your BV? Whats the clearance like?
Thanks
GSRswapandslow
01-29-2013, 01:23 PM
If you're using a T36....get signature zee high. If weight is an issue, get Kelby standards
Sent from my DROID X2 using Tapatalk 2
Weight is not an issue. I have been thinking about using the burris just wasnt sure which height. Will I be able to use the factory bases on the BV with the High Burris rings or will I still need higher bases? This Rifle is for my Cousin as I already have a 40x setup with a T36 and Burris Signature Zee Rings
scope eye
01-29-2013, 01:43 PM
The Burris high rings are almost .600 you should be fine with those.
Tanks Dean
How high is it from the top of the barrell to the top of the factory bases?
Thanks
scope eye
01-29-2013, 03:56 PM
On my rig the barrel is flush with they action, and then steps down 8" further down the barrel, but the scope bell is over the flush part.
Tanks Dean
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.