iraqvet13f
12-31-2012, 02:16 PM
All Savage Shooters:
I purchased the Weather Warrior in 22-250, and a Bushnell Elite 4200 8-32x40 AO (Adjustable Objective). Bought the setup for Coyote Hunting and Target shooting at 300-400 yards.
Rifle: Savage, Model 16 FCSS / 22-250 / Detach Mag / Duel Round Receiver Top / New Style All Round Barrel Nut / I believe standard Barrel Taper (definately not a heavy barrel, nor medium heavy barrel)
Note: I have never have had a Target Scope with an Adjustable Objective, so Im not sure which way to go for this set up. The scope is quite long as well.
My question's for ya'll are as follows:
1. Will the Low Rings be high enough, or should I go with Medium Height rings?
2. What scope base / ring combo should I use on this setup?
Setup's I have been looking into:
- DNZ / Low or Medium Height?
- Burris Tru-Mount Base with Sig. Series rings and Incert kit / Low or Med. Height?
3. I measured the Objective Bell / Overall Outside Diameter: 2.061 inches OD (Divided by 2= 1.0305 inches / minimum base-ring height-based on center of the scope), just trying to figure proper and lowest bases rings for this setup / clearance issues?
Your input is greatly needed and appreciated!!
Thanks for the help (in advance)!
I purchased the Weather Warrior in 22-250, and a Bushnell Elite 4200 8-32x40 AO (Adjustable Objective). Bought the setup for Coyote Hunting and Target shooting at 300-400 yards.
Rifle: Savage, Model 16 FCSS / 22-250 / Detach Mag / Duel Round Receiver Top / New Style All Round Barrel Nut / I believe standard Barrel Taper (definately not a heavy barrel, nor medium heavy barrel)
Note: I have never have had a Target Scope with an Adjustable Objective, so Im not sure which way to go for this set up. The scope is quite long as well.
My question's for ya'll are as follows:
1. Will the Low Rings be high enough, or should I go with Medium Height rings?
2. What scope base / ring combo should I use on this setup?
Setup's I have been looking into:
- DNZ / Low or Medium Height?
- Burris Tru-Mount Base with Sig. Series rings and Incert kit / Low or Med. Height?
3. I measured the Objective Bell / Overall Outside Diameter: 2.061 inches OD (Divided by 2= 1.0305 inches / minimum base-ring height-based on center of the scope), just trying to figure proper and lowest bases rings for this setup / clearance issues?
Your input is greatly needed and appreciated!!
Thanks for the help (in advance)!