View Full Version : Stock screw torque?
kayaker
12-26-2009, 06:13 PM
Hi all,
I was just wondering what the recommended action screw torque would be for a Model 11, syn stock?
Thanks
sharpshooter
12-26-2009, 06:33 PM
Hand tight.
Uncle Jack
12-26-2009, 07:00 PM
"Hand Tight"
That will vary a bit depending upon whether you are a 124lb Asian or a 240lb Irishman.
okie2
12-26-2009, 07:38 PM
IF IT MAKES YOUR BOLT HARD TO OPEN YOUR SCREWS ARE TOO LONG
jpdown
12-27-2009, 02:48 AM
I've always used 25lbs which is "hand tight" in a bedded stock.
Dennis
12-27-2009, 08:40 AM
I have always been told to tighten the front screw a little tighter than the rear screw (closest to the trigger).
kayaker
12-27-2009, 11:20 AM
Thanks guys,
Its appears the industry 'standard' is anywhere from 25-65. In their pillar bedded stocks Kimber recommends 45 front and 35 rear.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.