BVSS Finish

[teele1]

Can any one correctly tell me what the finish on a Savage BVSS stock is. I have let my dremel get away while cleaning up after bedding and need to repair a few places. I want the same finish as original so I don't have to take the entire stock down to bare wood.
Thanks in advance for the information.

[jpdown]

I've had best luck with Tru-Oil Gunstock Finish for touching up Savage stocks. Sand out bad nicks with 600 grit, dirty sand in Tru-Oil if bare wood is exposed and 0000 steel wool after each coat dry's. It takes several coats to build back up to the satin luster finish.

[jonbearman]

It is usually catylized urethane or something like it and is extremely hard to strip it.I used to take 5 minute epoxy and mix it like normal and thin it with acetone and brush touch the affected areas.You put a very light coat on and let it harden.