View Full Version : Need some help with Axis recoil lug
I am working on a new Axis stock and found the recoil lug is thicker than the Edge is. The Axis I am working on is .192 and my Edge is .186. Can you measure the thickness of your recoil lug and post the model and thickness. I am going to make a lug, Savage only sells the lug with the stock and a standard shank lug for a model 110 from Gun Shack is approx .245. Need help.
Thanks
RSG
fgw_in_fla
08-01-2012, 02:20 PM
I gotta Edge built in 7/11. Caliber is 25.06 Rem.
The slot in the reciever is .190" (+ or -.... it varies from end to end)
The lug in the stock is .188"
I hope that info is what you're after.
Frank in Fla
Thanks for the info Frank.
I was going to order a .1875 thk flat ground O1 bar to make the lug till I measured the lugs. What a pain if you want a stock with a lug and the factory stock with its lug.
I see your 25-06 is looking good. I am glad you are buying the .243 barrel, IT was haunting me as I looked for a 308 win or 22-250 barrel.
RSG
fgw_in_fla
08-01-2012, 03:36 PM
I'm looking forward to changing one of my calibers to a fat .243. If the accuracy & consistancy is anything like the 25, I'm really looking forward to it.
Good luck with your project. I have my Edge apart on the bench for a little cleaning & adjustments. If you need anything else, I'll check back again from time to time this afternoon.
Rainy afternoon. Perfect day to touch up the 'ol Edge.
Frank in Fla
Thanks again.
Frank, I need to tease you, I am keeping-a-eye on this for a Axis stock not your Carpathian curly maple but its maple.
http://www.ebay.com/itm/180941628920
RSG
fgw_in_fla
08-01-2012, 05:00 PM
Rub it in why dontcha......
Nap time. Rainy days & naps are what make middle age ----> approaching OLD age worth while.
Later y'all,
Rip Van Winkle....
bobfortier
08-01-2012, 05:30 PM
I di a slot with a .1875 router bit, and I adjust with a sharp chisel if needed
Bob,
I did the same. They want a lug for the new stock. Question? do you have customer ask for a recoil lug on your stocks?
RSG
drybean
08-01-2012, 09:19 PM
I am working on a new Axis stock and found the recoil lug is thicker than the Edge is. The Axis I am working on is .192 and my Edge is .186. Can you measure the thickness of your recoil lug and post the model and thickness. I am going to make a lug, Savage only sells the lug with the stock and a standard shank lug for a model 110 from Gun Shack is approx .245. Need help.
Thanks
RSG
guess i am cornfused,if you need a axis .188 lug i have one
drybean
Xaved
08-02-2012, 08:59 PM
Kind of a dumb question I guess: Why don't you just use the original lug? Mine pops right out of the stock on my axis when I take it apart.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.