Stevens 200 build (firing pin question)

[ss13]

I am converting a Stevens 200 .270 into a 300 win mag. I purchased the mag. bolt head and all other parts needed. Here is the question, do I need to adjust the firing pin protrusion after I install the mag. bolt head?

[joeb33050]

You need to CHECK, and ADJUST if necessary.
PM me if you need instructions.
joe b.

[BobT]

I just did the same bolt head swap on a Stevens, I didn't have to adjust mine but it was close to max length.

Bob

[Toyoda]

Joeb33050-I would like the instructions. I can't PM you :'(

[joeb33050]

Joeb33050-I would like the instructions. I can't PM you :'(


Send me your email address and I'll send it/them
joeb33050@yahoo.com
joe b.

[klayton83]

i think that when savage sends out a factory rifle it is a good thing to just go ahead and check the protrusion and adjust since it is such an easy process, just to make sure.