View Full Version : Removing mag well assembly 111FCXP3
Rattleakak
05-15-2012, 07:06 PM
I am getting ready to bed my stock and I need to remove the mag well assembly from the receiver of my 111FCXP3 (detachable magazine, button release on side of stock). How does one go about doing this?
Thanks
cgeorgemo
05-15-2012, 09:03 PM
Typically I smack it on the end with my action wrench with a rag on the mag to soften the blow a bit.
Others use a rubber mallet.
stangfish
05-15-2012, 10:24 PM
some place a thin screwdriver under the l bracket and rotate the tool back and forth till it lifts up. its all downhill fromm there.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.