View Full Version : Why do I need a piloted counter bore to install pillars?
jonrobinson
12-02-2009, 10:55 AM
Why do I need a piloted counter bore to install pillars?
Can I not just drill the existing holes out larger in a drill press?
Thanks for the reply. I have read all of the popular links on glass/pillar bedding. I am just not getting this part.
Jonrobinson
Eric in NC
12-02-2009, 11:09 AM
I don't use one - the drill bit will tend to wander when enlarging an existing hole but if you have the stock clamped on a drill press it can't move.
Forester
12-02-2009, 11:14 AM
I don't use one either, I do take all the time necessary to set the stock up on the drill press nice and square.
I usually use one because it saves set up time, I do my pillar drilling on a mill.
Bob
358Hammer
12-02-2009, 12:01 PM
When I was piller bedding I always use a piloted counerbore so I can follow a true existing hole. As stated, it sure saves time truing the stock to the tool for a precision hole.
If one is following a hole with a drill on a mill. The wood can not move if properly clamped. Maybe it was just me, but I got tired of the end of the hole drilled being off center from where I started drilling.
Put a piloted counterbore in the chuck and those holes came out nice with a minimum of setup.
Neal
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.