Need help

[Hippy]

I am trying to get my $%%##&& together and build a Savage- I Have two stocks, a Factory Laminated-fiberglass, two bbl's 204,223, tatical bolt handle,single shot adapter,FAT recoil lug , 223 bolt head,barrel wrench and Rifle Basic trigger( they one with the DVD instructions). I have been collecting these for over two years-ONE PIECE AT A TIME LOL

I have found a 200 Stevens in 308 for a VERY reasonable price ,(here is where the dilemma BEGINS) ::) I talked to the shop that has the rifle and asked him to measure the action bolt spacing and he gave me 4 3/8" , I figure 4.40 the stocks I have measure 4.275 as near as I can tell center to center. This shop is a 75 mile one way drive and if I call and ask him to remeasure he may get "Testie" >:( I am sure mine are rite as I used a dial caliber and both measured the same.

Will this/is this the right action for the stocks I have ???

Thanx,
Jim

[drybean]

no but you can always relocate the front piller

drybean

[EdKin]

Your stock is for the staggered feed action the one that the shop has is a newer center feed action. Look at the classifieds they pop up occasionally here or contact Jim at Northland Shooter Supply he may have a SF action. You can get the rifle from the shop and use that stock until you get one from Boyds, Stockey's, etc.

[stangfish]

....or you could get the stevens and sell your stocks then buy a new one later. You then would have a 308, 204 and a 223.