Accutrigger problem

[1luckeyt/a]

I have a 10fp h&s that has about 600 rds through it. The issue I have is when I close the bolt with any force the Sear is released, getting caught by the accuRelease. Changing the trigger pull weight doesn't help. I did notice that the pin that holds the trigger assembly in was bent. I Fixed the pin, and it did not fix the issue. Working the bolt all easy is not a solution for me. Anyone know how to fix this other than just putting an aftermarket trigger on it? Thanks.

[pdog06]

check to make sure the trigger assembly isnt rubbing against the stock anywhere.

[1luckeyt/a]

It still does it with the action out of the stock. I like the Accutrigger and hadn't planned on changing it, but I might later on. Being that I just picked up a m1a Im hoping there is a way to fix this other than throwing money at it.

[xpdchief]

How about getting Savage involved?, it shouldn't cost you anything.

[trappst]

Sounds like a trigger pull weight issue to me.......how much did you change the pull weight?

[1luckeyt/a]

Well before I straightened that pin i could adjust the tigger and it would still release. I fixed the pin, and added a little trigger weight, it does it less. Still not 100% though. Good enough for now though thanks for the imput.