wild cat info on 25x 7 mag or the 25x264 load data

[wilpenny]

I just purchased a Mark X thats set upfor the 25x7 mag. I think that the 25x264 is the same chambering in not sure . Any info would really help Thank U. I have found a set of the 25x264 but nothing on the 25x7mag
Wilpenny

[EFBell]

You may want to do a chamber cast. Did you get any brass with it? I'm guessing no?

[Apache]

You definitely want to verify the chambering. :o

Wouldn't want to make a mistake and blow a rifle up.......or yourself for that matter! ;)

[CJ in WY]

If the barrel is 25 caliber and the case is truly a 264/7mag, then you have essentially a 257 Weatherby without the funny round shoulders..... My bet it IS chambered in 257 Weatherby=Casting the chamber would be a very good idea!!

[wilpenny]

what do u use to make the casting ?? ive not cast a chamber before

[BobT]

what do u use to make the casting ?? ive not cast a chamber before


A product called Cerrosafe, it's a low temp alloy that is dimensionally stable. A Mauser chamber can be a little tricky to cast but since the stuff melts at under 200 degrees you can melt it out with a heat gun if you get some where it doesn't belong. I know that Brownells and Midway both carry Cerrosafe.

Bob

[BrentWin]

For a "how to" on chamber casting go to

http://www.midwayusa.com/General.mvc/Index/VideoLibrary

click on general gunsmithing and page down to "Making a chamber cast"

[wilpenny]

thanks for the input bob ill order the stuff and put this to rest after i can verifi the case then i can finish the rest of the rifle it looks like it was never bedded the stock looks like it was inletted for a bedding job that never was done who ever did the metal work and wood work was very good just that it needs to be finished ty Wilpenny

[okie2]

Cerrosafe melts at 158 degrees
for load data you should be able to use the low side
loads for the 264 mag and work up.