Fuzzyudders
12-18-2011, 07:38 PM
Hi there,
I am having an issue fitting a Hart LRT stock from Stocky's to a Savage 10FP, and could use a little insight. For the most part, the stock is a drop in fit. I cleaned up the inletting just a bit so that the rear pillar would fit flush in the trigger guard recess. Fitting the triggerguard itself proved to be a little more difficult.
http://i1135.photobucket.com/albums/m623/RedOneSix/DSCF1606.jpg
This is my triggerguard, the raised area in the front will not allow the guard to fit into the inlet flush with the stock.
http://i1135.photobucket.com/albums/m623/RedOneSix/DSCF1610.jpg
This configuration results in the rear action screw being about .2 or so too short.
http://i1135.photobucket.com/albums/m623/RedOneSix/DSCF1611.jpg
From the LRT page on Stocky's website:
http://i1135.photobucket.com/albums/m623/RedOneSix/triggerfit.jpg
Before I realized that the above said LRV, I went ahead and ordered a mod 12 triggerguard from the savage parts department. I received part #105417, which looks good on the depth, but not so much on the length.
http://i1135.photobucket.com/albums/m623/RedOneSix/DSCF1613.jpg
I was hoping that someone with prior experience with these stocks might provide me with the correct part number for a triggerguard. I've entertained the thought of getting a longer rear action screw from Brownell's, but I'd really rather buy the correct part, and have everything fit nicely. If you could point me in the right direction, I would really appreciate it. That being said, this stock is absolutely gorgeous. It's the Granite Grey color, but contains much more blonde than I anticipated, with some red streaks here and there, that make it look really sharp. Please pardon the awful pictures.
I am having an issue fitting a Hart LRT stock from Stocky's to a Savage 10FP, and could use a little insight. For the most part, the stock is a drop in fit. I cleaned up the inletting just a bit so that the rear pillar would fit flush in the trigger guard recess. Fitting the triggerguard itself proved to be a little more difficult.
http://i1135.photobucket.com/albums/m623/RedOneSix/DSCF1606.jpg
This is my triggerguard, the raised area in the front will not allow the guard to fit into the inlet flush with the stock.
http://i1135.photobucket.com/albums/m623/RedOneSix/DSCF1610.jpg
This configuration results in the rear action screw being about .2 or so too short.
http://i1135.photobucket.com/albums/m623/RedOneSix/DSCF1611.jpg
From the LRT page on Stocky's website:
http://i1135.photobucket.com/albums/m623/RedOneSix/triggerfit.jpg
Before I realized that the above said LRV, I went ahead and ordered a mod 12 triggerguard from the savage parts department. I received part #105417, which looks good on the depth, but not so much on the length.
http://i1135.photobucket.com/albums/m623/RedOneSix/DSCF1613.jpg
I was hoping that someone with prior experience with these stocks might provide me with the correct part number for a triggerguard. I've entertained the thought of getting a longer rear action screw from Brownell's, but I'd really rather buy the correct part, and have everything fit nicely. If you could point me in the right direction, I would really appreciate it. That being said, this stock is absolutely gorgeous. It's the Granite Grey color, but contains much more blonde than I anticipated, with some red streaks here and there, that make it look really sharp. Please pardon the awful pictures.