BAD BAD BAD BAD BAD ****UPDATE***

[dwa]

I took the dremel and relieved the stock where the mag goes. I am able to tighten them down and cycle the bolt with ease. thanks guys.

[Creeping Death]

If that doesn't work give this a try...

Use a dremel and a small diamond type stone and remove the head, then the stripped action screw's shank will be left and you can lift the barreled action out of the stock and just grab the screw's shank with vice grips and remove it. Takes some patience but it will work. I have removed quite a few bolts and screws that way.

Just an idea. May be easier depending on what tools you have available and may be less chance of stock and action damage?



+1 for the dremel. My dremel has saved my bacon many times.

[GaCop]

Amen to that!